4″ Electric Submersible High Speed Deep Well Pump

4 Inch High Capacity Submersible Pump

4“Max Flow 6m³/h

The pump use permanent magnet synchronous motor, all stainless steel multistage impeller, and the rotating speed is up to 5200 RPM. It Provides both built-in and external controller solutions, can be used for 3 phase AC or DC direct input (factory setting), and can be used with wide voltage;

Because the product has high power density and less impeller stage, breaking many traditional bottlenecks of deep well,it has constant pressure constant current water supply, intelligent operation, fault processing self function, wide voltage for the same performance, wide application scope;

At present, this product can replace the traditional deep well pump, and is suitable for the application of solar energy or battery, especially in the case that the depth of the submerged well is deep and the drilling cost is high. (it can drill smaller Wells with high power or large flow or high head);

4“Max Flow 12m³/h

This pump can be used in AC/DC direct input;

Built-in control system, intelligent drive adjustment pump work, save more power; Efficiency is 4-8% higher than that of conventional well pumps, exceeding the first-level energy efficiency stipulated by GB32030-2015;

Multiple protection procedures and temperature control protection strategies are built in, which will increase the service life of the traditional deep well pump by at least 60%;

Can use clean energy of solar power, energy saving, environmental protection;

The operation is more stable than low-voltage and low-power solar energy series, and the pump has stable output rated performance when the light intensity is high;

Longer use of battery power;

Small size, light weight and delicate appearance;

The whole pump does not contain any industrial oil and pollution sources. There is no need to worry about the pollution caused by leakage, which will cause greater economic loss and damage to health;

4 inch shaft driven submersible deep well borehole water pump

1. CE, GS certificate

2. 100% copper wire, automatic wiring

3. Cold-rolled silicon steel sheet, with high-speed punching, improve the efficiency and precision.

4. CNC precision automatic lathe for smoother shaft.

5. Strict tests include water test, outgas test and performance test, ect.

6. Anti-rust treatment castings and electrophoresis.

7. 30-year experience, 1 year warranty.

Electric Submersible Pump High-Speed Systems

Our electrical submersible pump design increases production in small-diameter wells, and the extended operating range reduces intervention frequency and cost.

Increase run time and production at a lower cost with our high-speed electric submersible pump (ESP) systems. They’re available for flow rates ranging from 125 bpd (20 m3/d) up to 4,400 bpd (700 m3/d) in casing sizes with a minimum ID of 3.46 in (88 mm) or larger.