Service
08:00~24:00(Beijing)
Water Pump Direct Sale
Professional Submersible Pump Manufacturer
Sewage pumps from SLAPK Water Pumps can handle the transfer of human and animal waste. Pumps commonly referred to as trash pumps, submersible sewage shredder pumps, and centrifugal sewage pumps often times fit into this category of pumps. These pumps are equipped to handle a ratio of up to 85% water to 15% soft sewage material, but no more solids diameter than the pump specifies. Our sewage transfer pumps cannot handle baby wipes, feminine products, diapers, and other element prone to clogging. It is helpful for these pumps to have a quick-clean-out for operations maintenance.
Sewage pumps are used to transfer sewage from domestic and commercial tanks which are located below existing sewage networks. Properties can be located in areas which are lower than exiting sewage pipe meaning gravity drainage can not be used. Pumps transfer sewage at high flows, and low heads to the existing sewage network which flows into sewage treatment plants for processing.
SLAPK supply high quality, European made multistage pumps for transferring clean fluids at high pressures, where single stage centrifugal pumps are unable to meet the requirements. We offer a range of multistage centrifugal pumps that benefit from compact design and can be installed horizontally or vertically. Suitable for clean, low viscosity fluids, high pressure multistage are available with the impellers installed either in series on the same shaft for higher pressure applications or in parallel on opposite shafts for installations where higher flow rates in.
So, if you are searching for an efficient solution with higher pressure capabilities for transferring clean low viscous fluids, we likely have the solution for you. Talk to our technical sales engineers today and find the right multistage pump for your application.
Centrifugal pumps are the most common pump for fluid transfer in high flow rate, low pressure installations. If a lower flow rate or a higher pressure is needed over what a single stage centrifugal pump can provide, a multistage centrifugal pump is a better suited alternative. Centrifugal water pumps are common single stage pumps, however due to the wide range of materials available centrifugal pumps can also be used for other low viscosity fluids such as fuel, oils and petrochemicals.
SLAPK Pumps offers a line of centrifugal pumps that complements both our pistons and plunger pump product lines. These pumps offer solutions to high-flow, low-pressure pumping needs. The pump housings are made of bulge formed 304 stainless steel that is stronger, lighter, more durable, and more cost-effective than conventional cast iron pumps.
There are over 100 models to choose from. Options include manual or automatic float (submersible), chemical resistant or high-temperature seals, and flanged or NPT fittings. Pumps can be built with several motor options: single or three phase, ODP or TEFC, 50 or 60 Hz, up to 575 volt, 1750 or 3450 RPM.
The SLAPK® close-coupled 316 stainless steel centrifugal units pump continuously producing high-head conditions. Designed for continuous high-pressure circulation and transfer of non-flammable liquids, utility, boiler feed, general transfer, filtration, cooling towers, condensate return, marine applications, fountains, boosters, water circulation, irrigation, spraying systems, jockey pump service, chemical processing, aggressive liquid applications and other general-purpose pumping compatible with pump component materials where no suction lift or no self-priming is required. L-4067 OIPM (High Head Close Coupled) L-4076 OIPM (High Head Pedestal) L-4077 Motor Manual L-4071 Seal Information